|

EMA Resources

Video

Home > EMA Resources > Videos > Auto-Assisted BGA Fanouts and Via Creation
VIDEO

Auto-Assisted BGA Fanouts and Via Creation

Increase fanout productivity of BGAs and other high pin-count devices with time saving automation in OrCAD.
REQUEST INFO
    VIDEO

    Auto-Assisted BGA Fanouts and Via Creation

    Duration: 00:01:24

    OrCAD PCB decreases the repetitive nature of BGA and other high pin-count device fanouts with time saving automation. Auto-assisted functionality streamlines fanout creation with:

    • Rule-driven fanouts
    • Multiple fanout strategies
    • Automatic calculation of pin escape angles
    • Automatic centering of vias

    More Videos

    Videos
    OrCAD X automated trace routing

    OrCAD X Presto – Next Gen PCB Layout Interface

    Place & Route with Ease in OrCAD X's New Layout Interface
    See Videos
    Videos

    LiveDoc – Automated PCB Documentation for OrCAD X

    Live Doc is an integrated solution in OrCAD X to create fabrication and assembly drawings. Have your artwork, charts and cross-sections along side your assembly data easily displayed. Add additional views or charts and easily modify them if needed. Add annotations, dimensions and other drawing features.
    See Videos
    Videos

    AWR Tutorial: Modeling a Diode

    Learn how to create a diode model from scratch in AWR Microwave Office using a SPICE model and package parasitic provided by manufacturers.
    See Videos
    Videos

    AWR Tutorial: Slotted Line Simulation

    Learn to construct a circuit schematic of a slotted transmission line and perform analysis by changing properties using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Effect of Changing Dielectric Constants on Impedance of Microstrip Line

    Learn how dielectric values effect the impedance of transmission lines and length using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Effect of Changing Parameters on Impedance of Microstrip Line

    Simulate the effect on impedance when we change in width of a line and height of substrate of a microstrip line in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Microstrip Line Design and Verification

    Learn how to design a microstrip line in AWR Microwave Office and verify the transmission line parameters.
    See Videos
    Videos

    AWR Tutorial: Voltage Standing Wave Ratio

    Learn what is Voltage Standing Wave Ratio (VSWR) and the effect of changing transmission line and termination on VSWR using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Mismatched Transmission Lines

    Learn how to simulate and analyze mismatched transmission lines in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Matched Transmission Lines

    Learn how to simulate a 50 Ohm transmission line terminated with its characteristic impedance in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Frequency Response of Op Amps

    Learn how to simulate and analyze the frequency response of an Op Amp using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Inverting Amplifiers with Ideal and Non-Ideal Op Amps

    Learn how to simulate ideal and non-Ideal Op Amps for inverting amplifiers and perform time domain simulation using AWR Microwave Office.
    See Videos

    Contact Us

    EMA Design Automation