Sigrity Aurora enables signal and power integrity analysis in the familiar OrCAD and Allegro design environment to achieve an analysis-driven PCB design flow. Earlier in this video series, we extracted a topology from Sigrity Aurora. In part 5 of this video series, we will discuss how to create a source synchronous topology. We will review how to set up and run a sweep simulation for different lengths, as well as generate the eye quality & measurement report.
In this video, you will learn:
- How to create a Source Synchronous topology
- How to set up sweep simulation and waveform for lengths
- How to generate eye quality and measurement reports
Download the demo files to follow along here.
This video is part 5 in a 5-part series:
- Topology Explorer Part 1: Design Setup for Topology Extraction in Sigrity Aurora 17.4
- Topology Explorer Part 2: Topology Extraction and Controller Model Assignment
- Topology Explorer Part 3: TopXp GUI Overview and Adding Circuit Elements for Simulation
- Topology Explorer Part 4: Adding a SPICE Model and Lossy Transmission Lines
- Topology Explorer Part 5: Source Synchronous Topology and Sweep Simulations
For step-by-step instructions on how to use the workflows included in Sigrity Aurora, view our free workshops at EMA Academy.
